Easy Steps to Lower Trigger Pull on Savage Axis Rifle

Easy Steps to Lower Trigger Pull on Savage Axis Rifle

Table of Contents:

1. Introduction
2. Step 1: Removing the Magazine and Trigger Guard
3. Step 2: Removing the Stock
4. Step 3: Adjusting the Trigger Spring
5. Step 4: Cutting the Coil
6. Step 5: Reassembling the Rifle
7. Conclusion

Introduction

In this guide, we will go through the steps on how to lower the trigger pull on your Savage Access rifle. This method is applicable for both the non-XP and non-Knox models. By making a few adjustments, you can achieve a lighter trigger pull, resulting in improved accuracy and overall shooting performance. So let's get started with the process!

Step 1: Removing the Magazine and Trigger Guard

To begin, remove the magazine from your rifle and set it aside. Next, you will need a 5/32 allen wrench or key to take off the back action bolt. This will allow you to detach the trigger guard from the rifle. Once the trigger guard is removed, you can proceed to the next step.

Step 2: Removing the Stock

Now that the trigger guard is off, you can easily remove the stock by unscrewing two optional screws. This will give you access to the trigger mechanism. The goal here is to create a lighter, non-adjustable trigger. By doing so, you will reduce the spring weight and lower the trigger pull.

Step 3: Adjusting the Trigger Spring

With the stock removed, you can now focus on the trigger spring. The pressure on the sear from the spring is what determines the trigger pull. To reduce this pressure, you need to remove a small c-clip, followed by the pin at the backside. Once the trigger is removed, you can proceed to the next step.

Step 4: Cutting the Coil

To achieve a lighter trigger pull, you will need to cut about one coil or one and a half coils from the trigger spring. Be cautious not to remove too much, as it may result in insufficient spring pressure to keep the sear engaged, making the firearm unsafe. Cutting one coil initially is recommended, and you can test the trigger pull to see if further adjustments are needed.

Step 5: Reassembling the Rifle

After cutting the desired amount of coils from the spring, you can now reassemble the rifle. Start by inserting the trigger back into its position and secure it with the pin. Make sure to put back the c-clip you removed earlier. Once the trigger is back in place, you can proceed to put the stock back on. Secure it with the optional screws you unscrewed earlier. With the rifle reassembled, you can now enjoy a lighter trigger pull and improved shooting experience.

Conclusion

Lowering the trigger pull on your Savage Access rifle is a simple yet effective way to enhance its performance. By following the steps mentioned in this guide, you can achieve a lighter trigger pull, resulting in improved accuracy and overall shooting experience. Remember to always prioritize safety and take necessary precautions when making modifications to your firearm.